search

0xD34D / ender3-v3-se-klipper-config

Klipper config for the Ender-3 V3 SE
108 stars 14 forks source link

Update printer-creality-ender3-v3-se-2023.cfg #21

Open T9Air opened 2 months ago

T9Air commented 2 months ago

The run_current for the stepper motors was too low, causing layer shifts. I raised the x & y stepper motors to .9, and the z motor to even it out. @0xD34D

0xD34D commented 2 months ago

What speed and acceleration are you running your printer at? I don't think an increase in current is needed for this example config as it is quite conservative with the speed and acceleration.

On a side note, I've ran my printer at 600 mm/s and 12,000 mm/s^2 and only needed to increase the Y stepper's current to avoid skipping, while my x-axis remained at 0.6A. I personally would not increase stepper current for axis' that are not exhibiting any issues.

T9Air commented 2 months ago

I am running it at 300 mm/s and 3,000 mm/s^2, with huge layer shifts on the y-axis.

0xD34D commented 2 months ago

@T9Air how does it perform at the speeds in this config? If people are experiencing layer shifting at these speeds, then a slight bump in the current might be warranted.

T9Air commented 2 months ago

@0xD34D I had such a big layer shift that I am assuming even at the speeds in the config, it would not be good. Also, a higher current is better as long as it doesn't cause it to overheat, and at .9 it does not overheat.

T9Air commented 3 weeks ago

@0xD34D I changed a few of the settings to match what is found in the ender 3 v3 se marlin config: https://github.com/CrealityOfficial/Ender-3V3-SE/blob/main/Marlin/Configuration.h