search

0xD34D / ender3-v3-se-klipper-config

Klipper config for the Ender-3 V3 SE
108 stars 14 forks source link

Octoprint? Are host commands enabled in your firmware? #6

Open km6lslf opened 10 months ago

km6lslf commented 10 months ago

I'd like to use my Ender 3 V3 SE with Octoprint, but with the stock firmware, it doesn't seem to work. Have you tested yours with Octoprint?

0xD34D commented 9 months ago

Octoprint can be used with klipper as far as I know. You'll need to see what's all involved but I believe it's easily doable.

km6lslf commented 9 months ago

Thanks, I'll check it out.

Thank you, Bill Kreutinger - KM6SLF Chief Radio Officer & Technical Director - Tri-Cities RACES 949-391-2342

On Tue, Nov 14, 2023, 7:51 AM Clark Scheff @.***> wrote:

Octoprint can be used with klipper as far as I know. You'll need to see what's all involved but I believe it's easily doable.

— Reply to this email directly, view it on GitHub https://github.com/0xD34D/ender3-v3-se-klipper-config/issues/6#issuecomment-1810500045, or unsubscribe https://github.com/notifications/unsubscribe-auth/ARKNSMTAR652RSYSQELXCS3YEOHPBAVCNFSM6AAAAAA7HAJFBSVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTQMJQGUYDAMBUGU . You are receiving this because you authored the thread.Message ID: @.***>