Closed infovore closed 5 years ago
Panel DXFs have 5.5mm holes at the corners, not 2.5mm.
The 5.5mm is the countersink; the drill should be 2.5mm.
This can be attributed to the DXF being extracted from fusion360 from the wrong side. Needs fixing ASAP.
(thanks, @okyeron)
infovore
commented
5 years ago infovore
commented
5 years ago
Panel DXFs have 5.5mm holes at the corners, not 2.5mm.
The 5.5mm is the countersink; the drill should be 2.5mm.
This can be attributed to the DXF being extracted from fusion360 from the wrong side. Needs fixing ASAP.