search

4712 / BLHeliSuite

https://drive.google.com/drive/folders/1Y1bUMnRRolmMD_lezL0FYd3aMBrNzCig
157 stars 52 forks source link

Please check data and power connection to the ESC #26

Closed NANDANSWAMY closed 5 years ago

NANDANSWAMY commented 5 years ago

I have connected Arduino UNO with ESC as follows GND to GND D10 to Signal and ESC power pin not connected. I tired to use BlHeli Firmware and tried Arduino BlHeli Bootloader. The connection was setup and I made the necessary changes in Select Atlmel/Silabs Interface. I'm getting the following error. Please check data and power connection to the ESC. I have used a SMPS power supply to power up the ESC. I am using Emax BlHeli 40A ESC

Accentrix commented 5 years ago

I believe your signal wire is suppose to be connected to D11.

See the manual: https://github.com/4712/BLHeliSuite/blob/master/Manuals/BLHeliSuite%204w-if%20interfaces%20pinout.pdf