I followed the instructions for the pressure advance and when I printed the test cube, there was no apparent difference in the corners. There were suggested settings, but nothing indicating what values you should change if you need to go beyond the suggested range.
I am using an Ender 5 Plus with SKR Mini E3 board (LIN_ADVANCE is enabled) and stock extruder my Cura Speed Tower Script settings are:
Command: Marlin Linear
Starting Value: 0.1
Value increment: 0.01
Change Layer 1.0
Change Layer Offset: 0.0
My Slicer settings are:
.4 Nozzle
Layer Height .2
Initial Layer Height .2
Line Width: .4
Top Thickness : 0.8 mm
Bottom Thickness : 0.8 mm
Infill Density : 0%
Print Speed : 100 mm/s
Outer Wall Speed: 100 mm/s
Inner Wall Speed: 100 mm/s
Initial Layer Speed: (leave it as your profile defaults)
Acceleration Control: Disabled
Jerk Control: Disabled
Coasting: Disabled
I followed the instructions for the pressure advance and when I printed the test cube, there was no apparent difference in the corners. There were suggested settings, but nothing indicating what values you should change if you need to go beyond the suggested range. I am using an Ender 5 Plus with SKR Mini E3 board (LIN_ADVANCE is enabled) and stock extruder my Cura Speed Tower Script settings are:
Command: Marlin Linear Starting Value: 0.1 Value increment: 0.01 Change Layer 1.0 Change Layer Offset: 0.0
My Slicer settings are: .4 Nozzle Layer Height .2 Initial Layer Height .2 Line Width: .4 Top Thickness : 0.8 mm Bottom Thickness : 0.8 mm Infill Density : 0% Print Speed : 100 mm/s Outer Wall Speed: 100 mm/s Inner Wall Speed: 100 mm/s Initial Layer Speed: (leave it as your profile defaults) Acceleration Control: Disabled Jerk Control: Disabled Coasting: Disabled