Open azalanono opened 2 years ago
https://github.com/5axes/TabAntiWarping/issues/2
Option Enable Support Brim
I have this same issue or believe I have it. This extension use to create a fill patter in a circular patter but now it does some lattace like pattern and sometimes causes a line to go right over a line just laid, will stick and drag it, then cause my print to fail at such an early stage. Can this be fixed as it use to work great when it did the circular pattern vs criss-cross stuff.
Ah....nevermind I found the 'Support Brim' option and enabled it. I must have disabled it at some point. Now they will print again without the criss-cross pattern causing it to fail. Thanks!
I use CURA 4.13.0 on Linux. A few days ago I installed TabAntiWarping because I wanted to try PA12 (Nylon) and have horrible warping.
In its current version TabAntiWarping is for sure not working properly.
It appears to me that TabAntiWarping needs a massive improvement. Currently it creates a fill identical to the infill selected for my part. So in my case I get a grid of 3x3 mm instead if a much denser one (able to stick to the bed). Such tabs are useless.
My suggestion: Add another setting, "Percentage of Tab Fill", for tabs.
I made a screenshot to show you what I get: