-
Приветствую!
Я очень впечатлён вашей работой!
Сейчас строю новый принтер (хобби) и нашел [этот "выпуск"](https://github.com/Klipper3d/klipper/issues/3741) (это великолепная работа!).
Я осознаю все …
-
I request a change to the board design to incorporate an ADXL345 in addition to the levelling sensor. As far as I can tell, no combined levelling and vibration tuning sensor exists. The Eddy is ideall…
-
I just received my FYSETC ADXL Nozzle-Attached PIS module, flashed both my mainboard and the unit with the most up-to-date version of klipper from my host PC, and upon defining the module in my config…
-
there is no wiring diagram for the adxl345 or pinout for this board available
-
Using RatOS-v2.1.0-RC2, Prusa MK3S does not generate configuration properly.
It is missing definitions for the display and filament sensor. It also assumes, regardless of having selected no accelerom…
-
-
Can I use adxl345 to do input shaping and if it is possible how would i do it.
-
https://github.com/MRX8024/motors-sync/blob/main/wiki/EN.md
From above macro consider adding the following portion to [adxl345] or [resonance_tester], wherever it applies.
```
#head_fan:
# …
-
I'm having the same problem as an earlier user. My error message is slightly different though: `Invalid adxl345 id (got ff vs e5)`
I'm using Rampon v04 because my Klipper version is v0.12.0-289 (bu…
-
После подключения акселерометра по приложенной статье столкнулся с ошибкой:
```
!! Invalid adxl345 id (got 0 vs e5).
```
Это связано с описанной в статье проблемой spi по 24 пину. WiringOP с коман…