-
According to my inverter, my two batteries are producing ~650W of power right now. At 52 volts, that's 12.5 amps, or 6.25 amps each.
But the logs are showing 648 Amps per battery. That can't be rig…
aren updated
16 hours ago
-
Is it possible to expose the amperage rate value to which you limit your on schedule charging to?
![image](https://github.com/bretterer/home-assistant-rivian/assets/16869713/e739d1ec-20a3-4898-b933…
-
would it be possible to have an amperage output as well? watts are actually really nice and useful, but I happen to have a lot of already recorded metrics in amperes instead of watts, which makes comp…
-
Hello, is there an amperage control limit? What amperage limit does this lib accept?
-
The code [here](https://github.com/Wakoma/nimble/blob/master/nimble_build_system/orchestration/device.py#L117) in device.py that gets the `shelf_builder_id` is supposed to just strip a trailing `-6` o…
-
If you can make a wider access of the voltage and amp control because if I don't set them it runs out of the limits 1.7A 4.4V so it would be nice to have the limit warning being actually Recommended l…
-
Hi. You made an great scheme, but i want to put about 20m strip to this controller. It will take about 25 ampers, but as i understand, maximum load is 4a.
What i need to change in this scheme to us…
-
Claim of 15% error on peak amperage
more or less across the board - low RPM/8A peak or 3000rpm 17A peak oscilloscope shows ~15% less amps than commanded
more data to follow
-
Would it be possible to add “motor amperage” to the Float Deck app. It’s a great app, but I know that it would be a big benefit to diagnose Onewheel nosedives or power losses if the motor amperage was…
-
Problem : when added as is , consumption and amperage is way over normal.
I found similar issue for the Tongou breaker so
I copied the PR2252 code and made a custom quirck for my model by adjusting t…