-
When I open simulation projects, especially in FMU settings, that has used pyscal to generate saturation table the Pc-curves is often quite unrealistic. and contains large entry pressures. This seem…
-
Capillary pressure is currently interpolated linearly, while it might make more sense to interpolate this logarithmically.
-
changes to opm-parser
-
I was reading through some of the opm-material codes. Some of the lookup saturations that are used in some of the classes (i.e. EclDefaultMaterial and EclStone1Material) seemed a little odd to me. I h…
-
T0 outbreak form is validated and approved by WHO for initial data collection in an outbreak. Inclusion of these variables in our schema enhances our alignment with the validated form for more widespr…
-
changes to opm-material
-
change to ewoms
-
**Describe the issue**
For multiphase poromechanics simulations on hexahedral meshes, the memory requirements of the constitutive models (multifluid, relperm, capillary pressure) are huge because of …
-
After scaling the relative permeability end-points of the model, I got the following error at 0 timestep: ```Program threw an exception: Could not find solution for PcEq = 0.0 after 60 iterations.```
…
ghost updated
5 years ago
-
This mysterious autosampler error was experienced during Tom P.'s run yesterday and during Shuo's run today. It prevented analysis. Resetting the injector, including power cycling, did not help