-
Hi Michael,
I just upgraded to this addon from the origin integration in HA. I use an automation inside HA to control the speed of the fan. After 2 hours the fan speed is still set back to the orig…
-
### The problem
comfoairq.0.sensor.awayIndicator
comfoairq.0.sensor.operatingMode
comfoairq.0.sensor.operatingModeBis
werden immer wieder auf 0 gesetzt und bleiben nicht auf den letzte Status.
…
-
### The problem
When first starting the adapter, the connection status (comfoairq.0.info.connection) changes to "true", which is fine.
After a while the debug comment states that the connection wi…
-
### Feedback
The documentation should state that the values are only valid when the comfoairq is 'alone'.
I have a comfofond 'in front of my comfoair'.
Comfofond-sensors are missing in the interf…
-
Hello
I am using the software. But there are 10-20 updates every second via MQTT. These almost always affect the "sensors" and "controls".
Is it possible to extend the software so that you can set…
-
I think there might be some mixup with the exhaust and supply values.
1. I have checked with the official Zehnder app, used its Unbalance setting and an anemometer that the values in the Zehnder ap…
-
Are there any plans to add some basic documentation? I'm trying to set this up.
* I have Homebridge installed on my laptop
* ComfoConnect LAN C (controlling a ComfoAir Q350 unit) is connected to t…
-
Might be a duplicate, took a look around but didn't see anything that directly mapped.
Every so often the bridge loses connection and my log ends up filled with things looking like this. The log …
-
Since there are a lot of similar issues, I'll create a new issue and link them all to this one.
This integration sometimes doesn't reconnect properly after the connection was dropped to the bridge.…
-
I've noticed `225` and `226` are related to the automatic mode.
My ventilation was running with a low fan speed, and in auto mode with humidity protection active.
Detected a high humidity (SENSO…