-
I would be great to add support for Hetec Cubecell - ASR6501 based boards. We have tried to use the board definitions for Arduino Zero (since we thought it shares the same MCU architecture), but it di…
-
We are expecting different problems with the CubeCell using the micros() function.
To reproduce:
```
#include
uint32_t last = 0;
void setup() {
Serial.begin(115200);
delay(2000…
-
The [CubeCell GPS-6502](https://heltec.org/project/htcc-ab02s/) is an SX1262 board and has GPS capability, but we just need LoRa and OLED display working for now. Explicitely supporting GPS within the…
-
Would it be possible to support this particular board with the mcci arduino-lmic stack?
https://heltec.org/project/htcc-ab01/
It consist of a ARM Cortex M0+ microcontroller plus a Semtech SX LoRa …
-
Is there any porting guide?
I would like to port tinygo to Heltecs Cubecell SoC. A doc explaining where i have to place which file would be really helpful.
With kind regards,
Mia
-
Hello!
I tried to run the configAir530_Vaelid.ino file and upload it to Arduino, but I get a compliation error in that in cannot compile the following inclusion:
#include
From what I could …
-
I'm attempting to join an HTCC-AB01 Cubecell node to a private gateway. I've successfully joined a Heltec esp32 to this gateway.
With the CubeCell device I'm unable to successfully join (accordi…
-
I was looking at the dryad https://www.dryad.net/wildfiresensor sensors, and after a bit of research I got myself a bme680 and a cubecell ... I guess we had the same idea. I still didn't have the time…
abate updated
2 months ago
-
I'm not sure where exactly to report this, as it can more than likely be a hardware issue. But making a note here for reference.
While cleaning up TTN Mapper data I stumbled on a pattern where Cube…
-
Zi-x updated
10 months ago