-
When I set my 5020 to 10V, it will only change around 15s later. All functions, including function generator seem delayed.
If the function generator is started, turned off 5s later, the function gene…
-
Hey ho,
Is the Firmware tested on a DPS 5020 and/or a 8005?
I'm quite sure the 5015 and 5020 shouldn't be so different internally.
About the 8005 no clue O_o
-
Before the changes, when setting 2 amps, the device was set to 0.2
To correct it, I have changed 100 ==> 1000 on the following lines in pyDPS.py:
line 161: self.power_supply.write_regis…
-
I have compiled for the DPS5015 (v2.3) but output values are inaccurate - see photos.
I set 3.300V - once output is enabled the DPS5015 screen shows a voltage slump to 2.84V and I measure 2.858V
…
-
How does your PSupply survive, given https://www.droking.com/cs/support/topic/backdriving-the-200310-as-a-solar-battery-charger/.
Mine didnt.
-
As mentioned in #17, a PID controller would be very useful to maintain output power while under load.
-
Hi, I bought a dps5015 fairly recently from a distributor called "KKmoon" from Amazon EU, and I quickly put in opendps after I did some testing on the stock firmware.
Two problems as I can tell rig…
-
Hej
I wasn't able to send any command through the serial terminal. I get a lot of feedback from the ESP32S about whats wrong with the voltages and so on. But it doesn't accept any commands.
So I…
-
Hello!
Has anyone tried to flash a DPS5015 hardware rev. 2.6 with opendps recently?
I noticed that the background light is contantly on but nothing is getting displayed after flashing.
After that…
-
OSP running on esp, all good. If I send outputEN=0 command, can see power icon turning red on the dps, but after few sec is back green again.
Same behavior if turning off via button on dps - it turns…