-
Hi friends,
Is it posible to use DRV8825 stepper driver with gobot?
Thank you, very much.
-
I installed 3 drv8825, x,y and z directions. Works great.
But if I am putting a drv8255 in the extruder place the usb connection to repertier host crashes a lot. I am using the newest version here. A…
-
I was wondering if these settings are correct. So with step doubler 16000f / 320 steps/mm = 50 mm/s would be the printing speed.
But what if I would like to print faster and have travel speed of 100…
-
Hello,
I have noticed with the traditional drivers that microsteps are NOT all equal.
For example at 1/8th using an A4988, the various microsteps are definitely not 0.225° appart (360/200*8). Al…
-
Hello, I got some TMC5160 v1.2, can they be used to replace drv8825?
-
I was building a robot inspired by what you were inspired by, but with your code I managed to balance it, but I couldn't control it via WIFI, as it always falls, do you think the DAC soldier on the DR…
-
### Description
I read on the wiki for the installation of the frimware but I wanted to install the MK4 cart present on thingverse.
This cart has different deltas for the BLTouch position an…
-
Hello MK team!
I hope you can hell me here.
### Issue description
G28 command is not working. If I send it in the terminal the board answers ok and the axis current position but nothing moves.
…
-
**Application version**
Cura 4.3
Cura 4.2
**Platform**
Windows 10
**Printer**
Hephestos with SKR 1.3
X and Y: TMC2208
Z and Extruder: DRV8825
**Reproduction steps**
Just prin…
-
I just received the board, installed the firmware, installed correct pins and installed DVR8825 drivers but I get no movement from the stepper motors, not even a slight resistance when turned by hand.…