-
connect to OpenEarable, then tap on it to disconnect. it is no longer possible to connect again
---
reported by @kkai on iOS
-
Is it theoretically possible (i.e. possible with the Arduino's processor) to add more voices to the output?
-
Subscribe to this issue and stay notified about new [daily trending repos in c](https://github.com/trending/c?since=daily).
-
Dear all,
I am writing a simple testing code for the board, which is for detecting if an SD card is inserted and available. However, it seems that the code is not working ever with my SD card alrea…
-
even if no OpenEarable is connected, the recorder should be available to get the data that was previously recorded
---
reported by @kkai on iOS
-
I am working on an app as part of the lecture MoCIoT, where I am using acceleration data of the device. When I navigate to Sensor Data --> Accel., I noticed that when I hold the device upright, X and …
-
would be nice to have a toggle switch on the connectin page that can be used to enable automatic reconnecting
questions
- [ ] how should the recorder handle reconnects?
- [ ] can we make this sta…
-
when i run the openEarable with the dashboard, the CSV that i generate after clicking "stopping recording" is always empty. i was looking into more how the dashboard and the openEarable communicate th…
-
-
Hello, I am trying to use Arduino IDE to upload some new sketch to the open wearable board via Arduino IDE. However, when I try to connect the open wearable board via a USB cable and use Arduino IDE t…