-
Just wanted to thanks you for your code !
I had an Attiny85 and FS1000A on the bench so decided to give it a try instead of buying new hardware... (I know other github on tesla door opener mention…
-
Hi,
I was trying to sent temperature using ArduinOregon to Oregon Scientific RAR681. The hardware is Arduino UNO with FS1000A. The receiver did not display the given temperature.
Could you advise…
-
I'm using rc-switch with fs1000a (433Mhz) module and it works fine, but i'm trying to read my car key (with the rolling code i can't use that input for nothing, just for learning) but it doesn't read …
-
Доброго времени суток, пытаюсь заставить работать скетч examples/base_rx на nodemcu (esp8266), в качестве передатчика использую attiny13 + fs1000a , в качестве приемника модуль syn480r подключенный к …
-
Hello,
I wanted to update my Signalduino and have flashed the current hex file. After that, I can not longer receive or send correct signals. Has anything changed here?
I have flashed with the follo…
-
Hello, I have the following setup:
1) Sniffer: Arduino uno with standard MK device. I'm using receive_demo_advances as sketch
2) NodeMcu: amica v2 with fs1000A Transmitter device
My goal is to …
-
Hello,
I am using this excellent project like a bridge of IR + RF433 + Bluetooth
Since I started to use the bridge, I could see some interference at home with other RF 433 devices (for example in m…
-
Hello,
thank you very much for your nice software.
I have now a setup, where I use tronferno with an additional ESP32 OpenMQTTGateway (esp32dev-rf).
With this
-
### The problem
HI,
Got an 433Mhz RF emitter and receiver on an ESP32.
Both my emitter and receiver are working properly.
I'm capturing this data (protocol:8) from my remote :
`[I][remote.rc_sw…
-
hi guys,
i'm trying to sniff a 315mhz static code remote with NodeMCU v2 and MX-RM-5V module (version at 315) without success.
It seems that the NodeMCU don't found the board. I've used differen…