-
I bought the Spider-H7 and on the packaging it shows a link to a wiki article that does not exist, and a github repo that does not exist.
Links:
https://wiki.fysetc.com/FYSETC-SPIDER-H7
https:/…
-
When using ./install.sh -i, MMU_GEAR_UART is assigned to gpio20, which according to Fysetc's own documentation should be gpio11.
npa62 updated
2 weeks ago
-
### Describe the feature or hardware support you'd like
Could you add Fystec hotkeys in the future?
I've installed this addon on my voron 2.4 and it's very useful feature.
### Additional conte…
-
Id like to ask you, if there is any compatibility problem to use BTT EBB 2209 CAN toolhead with Spider V3 controller?
I flashed firmware on both (Spider3 and EBB CAN module), controller is normally…
-
Hi,
I didnt realise there was a difference between BTT drivers and Fysetc.
Can someone please advise what jumper settings i need to use to make these work
![20240704_211220](https://github.com/…
-
At the start i must say i'm total new with arduino ide, so i might be doing something wrong, however i'm trying to use 3d printer board for other purpose, but by all means i can't get it working.
The…
-
If someone wants to connect two at the same time, here is the config.
`# Obtain definition by "ls -l /dev/serial/by-id/" then unplug to verify
[mcu hotend]
serial: /dev/serial/by-id/***
[mcu bed…
-
# Issue
After starting a measurement with my UCAN FYSETC Adapter in cangaroo the error `timeout waiting for canifconfig` appears in the log. cangaroo tells me that it is listening to interface can0 …
-
Looks like it is supposed to have already been addresses in "Update platformio.ini to fix class WiFiClientSecure compilation error" {4b360345fc22ea1cb86909525ceb3c459a040e4e}, but for me it's still fa…
-
Got sensorless homing working fine with FYSETC TMC2240 and the following config:
[tmc2240 stepper_x]
spi_software_mosi_pin: PB15
spi_software_miso_pin: PB14
spi_software_sclk_pin: PB13
cs_pin: P…