-
NeoAir devices appear to work in mode 1 - Thermostat but I cannot say how completely this works.
More testing is needed in Mode 1 - Thermostat, Mode 2 - Timer, and Mode 3 - Thermostat and Hotwater.…
-
Hey 👋
I am probably doing something horribly wrong but it seems that I cannot set the hotwater temperature via Homeassistant. The Error log I get is attached. It seems that the component is calling …
-
I've got an Ochsner GMLW 19 with TEM-Controller connected to with john's ebus adapter.
ebusctl find:
.
address 15: slave #2, scanned "MF=TEM;ID=24849;SW=0604;HW=0102"
.
I'm using 15.24849.HW01…
-
Hello!
It would be nice if you added ON command. If you turn off water and zone 1 you can't turn it back on only bu enabling zone 1 or hot water. First you must turn it ON then activate zone 1 and …
-
Using this library via [nut_exporter](https://github.com/DRuggeri/nut_exporter), I was getting errors with my UPSs:
`ts=2024-03-28T15:25:22.903Z caller=nut_collector.go:131 level=error msg="Failure g…
-
I have a Vaillant heat pump VWL 125/5 with sensoCOMFORT module (VRC720) and sensoNET module (VR 921).
I want to be able to start (and stop) hotwater boosts and zone quick veto sessions via ebusd to u…
-
Looks like the description of the **hotwater** settopic value is incorrect here:
https://github.com/rvdbreemen/OTGW-firmware/wiki/Using-the-MQTT-set-commands
Instead of :
`temp = [number e.g. 20.…
-
I can set it to manual or schedule but if I try and turn it off the call just seems to be ignored.
I have tried -
hotwater.SetState(hotwater.State.Off);
hotwater.SetState(hotwater.Mode.Off);
h…
-
### my use case that triggered the bug
I created 2 target devices related to hot water heating. Both referencing the same datapoint with same target temperatures for on/off states. One is called _hot…
-
### The problem
I've been toying with the dev version of HA to try to make my HomeAssistant show all of my ViCare sensors and connected stuff.
I do see the device in the diagnostics as well as the d…