-
Hi,
Nice work on figuring out the iRT protocol! I want to monitor my EcomLine Classic HRC30 UBA4000 (1997 o_0) with Moduline 300 thermostat so I made a circuit that listens to the bus using a seri…
-
**Question**
I ordered a iRT Board that came today - flashed it with the latest bin 1.9.10 , got wifi running, connected it to my iRT Bus , set passive mode in Config, rebooted , telnet the device, s…
-
**What happened**:
VM is not booting, just showing a transparent screen when I type:
./virtctl-v1.3.0-linux-amd64 console rocky
 GB112 Buderus boiler.
I buyed also a EMS-Gateway from BBQKees and a Junkers/Bosch EasyControl adapter. In addition …
-
Dear Victor,
I'm trying to compile the firmware with the help of Gitpod.
I'm famliar with Tasmota and it works pretty easy to run one's own compiled firmware in Gitpod.
Is there something simil…
-
Running in KDE, Chrome is unable to communicate with the KWallet keyring.
> [2:2:0101/023234.222060:ERROR:kwallet_dbus.cc(100)] Error contacting kwalletd5 (isEnabled)
Starting chrome with `--tal…
-
Dear maintainer(s),
We, @AnStaes and I try to run a bigger job of 98 .d files on a current Debian Linux system with 64 CPUs
with the following options
```
--fasta /scratch/cpanse/vib/UPhuman…
-
Would it be possible to use this firmware to monitor my iRT installation and occasionally control the temperature of my heating while keep on using the thermostat?
-
I managed to install on my Wemos D1 mini with the help of the "trick" referenced below.
Then I can connect to the WiFi AP, and open the web interface, but it does not respond to any setting I try t…
NiekD updated
2 years ago