-
I have an arduino nano v3 and a RFM69HW. Everything works fine, but when I set: `radio.setHighPower();` it gets blocked when I perform: `radio.send(TONODEID,sendbuffer,9);`.
The RFM69HW is fed usin…
-
This may be related to #294 . I am trying to use gpredict for greencube. To define both the uplink and downlink frequencies, I added the following section to `~/.config/Gpredict/trsp/53106.trsp`:
```…
-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### What part of EdgeTX is the focus of this bug?
Transmitter firmware
### Current Behavior
I have a X9E…
-
### What radio module do you use?
E01-2G4M27SX (nRF24L01+), E01-ML01DP5 (nRF24L01+PA+LNA)
### What driver board(s) do you use?
ESP32-WROOM (ESP32 Dev Kit)
### If using Linux, what OS are y…
-
# ESP32-C5 support status in ESP-IDF
ESP-IDF v5.4, currently in development, will include initial support for the mass production version of the ESP32-C5 chip.
In the list below, supported featu…
igrr updated
11 hours ago
-
Hi,
I really appreciate your useful library. However, I encountered a problem: I couldn't tune to frequencies under 87MHz because I live in Japan, where our frequency range is between 76 - 108MHz. …
-
### SOC
Other
### Lora IC
SX1262 (inside STM32WL)
### Product Link
https://www.seeedstudio.com/LoRa-E5-mini-STM32WLE5JC-p-4869.html
### Description
There is currently a variant of the firmware …
-
Add underwater radios (and underlying calculations)
A few points to be considered:
- Underwater Communication is not trivial
- Only low frequency communication is useful
- Investigation on Radios and…
-
The radio connects to the car via a spade terminal ground connector, an aerial coax connector, a round multi-pole connector for a CD changer, a rectangular multi-pole connector for power and speakers …
-
Suggest looking into if possible to replace ESP32-C3 SoC with ESP32-C6 in next-generation of WiCAN hardware for the future.
https://www.cnx-software.com/2023/01/12/esp32-c6-wifi-6-ble-802-15-4-modu…
Hedda updated
4 hours ago