-
Hi, I am trying sdi12 with mkr1300 board, The probe is getting detected and when I read the sensor data only battery voltage is coming. but temperature salinity and moisture values are not coming. If …
-
In order to build locally, add a testDependency pointing to arduino-mkr1300 in pxt.json
```
"testDependencies": {
"arduino-mkr1300": "*"
}
```
-
Hello.
Thanks you so much for the work you are doing with your library.
I have been using it for a while to communicate between 2 ARDUINO MKR WAN1300, a transmitter and a receiver.
It works very we…
-
I was testing LoraSendAndReceive sketch with MKR 1300 WAN as node and a PyCom LoPy as "nano gateway" with The Things Network.
Pycom "nanogateway" / TTN can occur in "join accept" downlink timing prob…
-
Hi,
Which SF does the library support ? Is it possible to modify it ?
Thanks for your help.
-
When using joinOTAA() with band set to AU915, my nodes send join requests on frequencies between 902 and 928. My gateway is (correctly, I think) ignoring messages sent on frequencies outside of 915 to…
-
Hi! I'm making test with the arduino mkr 1300 + TTN, and the downlink not work, the ttn application data by node show me than the payload bytes was sent (downlink) but in the monitor serial (arduino)…
-
Has someone been able to configure the mkr wan 1300 using the MKRWAN library on the us915 band? I'm not able to see any packet going through the gateway (This is configured with the 915E6 band as well…
-
Hi,
I've spent the last few days trying to get to the bottom of this. I think I've narrowed it down to a combination of ABP join with OTAA registration.
I am using this updated firmware by @flhofe…
-
After reviewing the various issues with this library and fw https://github.com/arduino/mkrwan1300-fw I decided it was probably a better idea to investigate with the community about the next steps (bef…