-
The fw file for pico w starts with:
`FCYW4343A2_001.003.016.0031.0000_Generic_SDIO_37MHz_wlbga_BU_dl_signed`.
Read_RAM returns status 0x12 for all addresses.
Is there a way to get this to work?…
-
How to change the config to get an image to upload into Raspberry PI pico w?
-
## Steps to reproduce:
- In the host Pico-W load [Pico-W AP example](https://github.com/raspberrypi/pico-examples/blob/master/pico_w/wifi/access_point/picow_access_point.c).
- In the second Pico-W l…
-
Hi Chaps
With some direction from Patricio, I have implemented the UDP stack in seqs.. I can now pull binary files with a naïve, "reliable" protocol on top. (Yes, I know I could have done that with…
-
### Minimum requirements
- [X] Core clock speed is 48 MHz or faster?
- [X] Is the CPU an ARM Cortex M0+ or later?
- [X] Does the host microcontroller have at least 32 KB of flash memory?
- [X] Is the…
-
The various CMake link library options **pico_cyw43_arch_...** only have any affect if the CMake call defines **PICO_BOARD=pico_w**. Otherwise they default to no-op.
This causes problems if (for ex…
-
FOR THE PICO NOT PICO W
Describe the issue
When I plug in the pico, it doesn't run the payload, instead shows up as a usb. If I push the jumper cable harder and reconnect, nothing shows up, but stil…
-
Hi,
I tried to compile picoprobe for the pico w. Anyways, the pins for LED and SWD have changed on the pico w. Is there already a common solution for this? Else I would change the picoprobe source …
-
Unable to compile arducam_mini example in Arduino IDE 2.3.2
Have #defined OV2640_MINI_SMP_PLUS in memorysaver.h
and uncommented
#define ARDUCAM_SHIELD_REVC
on attempting to upload the sketch …
-
I built two lora system with below configuration.
1. NodeMCU+ SX1262
2. Pico W + SX1262
Now, I want integrated with ESPHome with External Components.
To start with I want to first send yo…