-
Question:
How easy is it to use your code to drive the anycubic TFT on a regular RAMPS board?
Presumably there is a lot of code in this branch that deals with the weird ways anycubic had the trigor…
-
No puedo controlar la impresora desde la pantalla. Cambie la Rampas 1.4, el arduino y la pantalla MKS (Las que tengo son las tft 28 V4.0) ha modificado los baudios en el marlin así como en la pantall…
-
Hi,
I'm facing an issue with mi MKS TFT 28. I'm trying to attach it to a RAMPS 1.4 board, however there is no communication at all.
I tried to change baud rate on both boards but nothing.
I'm a…
-
Hello,
I'm using TFT 2.4 v1.1 with arduino mega and ramps 1.4 (1.6 too)
it works fine on USB power only
when i connect it to power supply it keeps restarting for ever
i disconnected the TFT and …
-
The original MKS TFT28 supports wifi using the MKS HLK-WIFI module.
Is this supported with your firmware?
-
my MKS tft is now running on a Ramps 1.4, if I have connected the tft the control via USB (Octoprint) does not work anymore ... is that the same USB port ..? can one adjust this in Marlin?
-
Hello,
I wonder if I risk damaging the TFT with the 5V logic of the ramps/arduino card passing by RS232 connection (only touch mode).
-
Hi
Im trying to connect MKS TFT 2.8 V1.2 with ramps.
Well even though using the latest SW 3.01. of MKS board cannot communicate with ramps. In ramps wire is connected in AUX-1 with red wire t…
-
Hello,
I use MKS RUMBA board, and I would like to use my MKS TFT35 with the great [ESP3D-WEBUI](https://github.com/luc-github/ESP3D-WEBUI) web solution.
Problems:
ESP3D-WEBUI or web pages can't be …
-
Hello! I have acquired a tft28v4.0, as soon as I installed it and had no communication with my ramps 1.4, I changed ramps and arduino but the problem persists. I then bought a tft35 v1 to build my pri…