-
Hello,
Currently I am trying to make this work with a test setup of the Renogy Rover MPTT 40A controller. I have only a Mighty Max 12V 100Ahr connected to Bat (+) and Bat (-). PV(+), PV(-), Load(+)…
-
Port https://github.com/cyrils/renogy-bt/blob/main/renogybt/RoverClient.py to esphome
-
I have it working with an ESP32-WROOM-32D board and a Rover Li 40 amp SCC
-
Hello!
I received my `RNG-SYNC-V3-B32B` today and could immediately get data out of my Renogy Rover. Works flawlessly.
However I noticed an annoying problem: I can not add the power generation a…
-
Good afternoon,
Attempting to get connected to my PowMr solar inverter (POW-LVM3.0K-24V) that appears to be a clone of a Renogy unit. I was able to complete the configuration and the RS485 device…
-
Hi, thanks for this project. I have 60A MPPT Renogy Rover and am trying to communicate with a MacOS via RS232 cable DB9 connector. When I run renogy_rover.py I get this error:
```
"/Users/ed/Des…
-
I found out that my controller lives at address 17; not 1 which is typical for renogy controllers.
SP410 updated
2 months ago
-
Hi ,
Anyone have this kind of error?
pi@renogyrover:~ $ node-renogy -s /dev/ttyUSB0 -m 192.168.0.11 -u mqtt -p mqttpasswd
[1658487181379] INFO (9450 on renogyrover): Starting NodeRenogy...
[165848…
-
Hi
any support for Renogy rover Eltie via BT-2?
have the error ERROR: Error importing RenogyRCC40
-
Hi
great project.
I am wondering if this will be enhanced by other Renogy products?
I understood that the DCC50S uses a different version RS485 and is not compatible with the ROVER
Thanks…