-
The firmware of my printer (Renkforce RF2000) is based on Repetier.
It supports bed scanning and can output the bed matrix like this using the GCODE command `M3013`.
See also https://www.rf1000.de/w…
-
**Application version**
* I am using Ultimaker Cura V 4.7.1
**Platform**
Windows 10 Pro 64 bit
**Printer**
* I selected "Custom FFF printer" but I want to connect to a "Renkforce RF2000 V2"
…
-
I have huge problems with RF2000.
From time to time the LCD is going completely blank.
I have had over 20 problems with auto leveling, where the leveling was not completed . turning on and off the …
-
### Version
2.4.0 beta1 win64 (and **presumably earlier versions**)
### Operating system type + version
Windows 8.1
### 3D printer brand / version + firmware version (if known)
Printer:…
-
**Describe the bug**
The support material is not printed for the first layer and as a result the support is printed in the air.
**To Reproduce**
Steps to reproduce the behavior:
1. Upload the mo…
-
Hello there :)
We dont want to keep our findings a secret. Thatwhy I post this here:
Playing with the PID control did improve a lot in my firmware. But the heated beds where not perfect. So we tri…
-
Hello All,
Thank you and John Silvia for the great piece of software. I am finally printing with a 32-bit CPU. While setting up, I noticed I was not able to calibrate extrusion - it was inconsiste…
-
Wieder gabs Ärger damit.
Wir sollten das rausschmeißen...
-
Ich verstehe seit kurzem das Ergebnis des Z-Offset-Scans nicht mehr. Erstmal behauptet er immer, "Z-Skrew too low". Die Ziel-Position der Schraube scheint außerhalb des gültigen Bereichs zu liegen, we…
-
Installed the newest development build: 1.47.00
right after the upload the temperature manager sensor error appears.
On the display all 3 heating zones are only diplayed as def/0
Tried to find out…