-
### Problem description
The device connects to Home Assistant correctly. Firmware and diagnostic information is shown. It is, however, not possible to control the color/brightness/pattern of the LED …
-
Feature Request: Add support for TCS34725 ahd VEML6040 RGB Color Sensors as device tree overlays.
Example of TCS34725 RGB Color Sensor...
https://www.adafruit.com/product/1334
VEML6040 RGB Col…
-
The problem
-----------------
Domoticz MQTT-AD defaultly sends this payload for RGB devices:
{"color":{"b":77,"g":132,"r":255},"state":"ON"}
It also contains a "hack" to send this payloads for F…
-
Device: Shelly Plus RGBW PM
Version: 2.12.2
Hi.
When cycling power the device has lost its configuration and starts to AP mode again. The module loses all its settings and looks like it resets…
-
### The problem
Shelly RGBW2
Device Firmware: 1.4.4 (current)
When you add a Shelly RGBW2 in 'rgbw' mode it will show only a single temperature sensor under Diagnostic:
. However, I get the error in the image.
**To Reprod…
-
Switching a device to white doesn't work correctly. This issue has already been raised twice in the last two years (Issue #140 & Issue #305) but both were marked as stale.
In #305 someone resolved …
-
My home automation system (Vera) sends UDP commands to an iBOX that then controls RGBW LED strings using FUT038s. I installed a few more locations and set up a NodeMCU esp8266 milight hub to control…