-
Hello.
I want main.hex and eeprom.hex file that I can upload to MCU.
I have STC15W404AS Chip in the pcb. I do not have knowledge to use compilers.
I use the STC-ISP program v6.86U
Thanks.
-
Hi Dear Sir IceG
After doing this command (advised by IceG)
```
root@OpenWrt:~# rm /usr/share/3ginfo-lite/modem/usb/2cb70104
root@OpenWrt:~# cp /usr/share/3ginfo-lite/modem/usb/0e8d7126 /usr…
-
rt, Is it possible to have Windows release?
-
```
stcgal -p COM3 -P stc8 .pio\build\STC8H1K16-rev52\firmware.hex
Waiting for MCU, please cycle power: done
Target model:
Name: STC8H1K16
Magic: F721
Code flash: 16.0 KB
EEPR…
-
I will hear a ding sound after a process exits it self. Is there any way to disable or supress this sound?
-
Hi!
This has been so valuable, thanks so much for your hard work!
I was working at getting your examples for the STC8 to compile under Keil 5, and noticed that the Nuvoton N76E003 was selected a…
-
Hello,
I am using a PCB that contains the STC8A64D4-LQFP44 device. The board contains a FTDI device (FT234XD-R). When plugged in the FTDI chip is powered from the USB but this rail is not shared …
-
更新了程序固件
更新内容:
优化了界面显示,降低了数据刷新速度。
增加了一键休眠功能,主界面下长按M键进入休眠模式。
缩短了开机化锡时间,现约8s左右。
烧录前注意事项(重要!!!):
因为flash会被重置,烧录前务必记好自己设备的温度偏移量,烧录成功后自行恢复该偏移量!!!
烧录步骤:
1,电脑下载安装CH340驱动,下载STC-isp
2,拆开电烙铁,取出PCB…
-
Hai,
I had seen your program, but i want to write the this program fr 9600 baud rate. how to do it?
Regards
Praveen M
-
It'll be nice to have STC's official fancy U8W programmer support. It's an inexpensive(15 USD or 12.7 Euro) dedicated programmer for all STC micros with a few additional features such as offline progr…