-
- [ ] Footprint
- [ ] Schematic
- [ ] Create part
- [ ] Connect to STM32
- [ ] Profit!!!
#### Data Sheet: [UM2502](https://www.st.com/resource/en/user_manual/um2502-stlinkv3mods-and-stlinkv3min…
-
I got a stm32f4 and wrote some code to it, then tried to run openocd and got this error
C:\Users\eyala\Documents\OpenOCD-20240916-0.12.0\bin>openocd.exe -f openocd.cfg
Open On-Chip Debugger 0.12.0…
-
- [x] I made serious effort to avoid creating duplicate or nearly similar issue
- [x] Programmer/board type: [STLINK V3 Mini] (e.g STLINK /V1, /V2, /V2-onboard, /V2-clone, /V3)
- [x] Operating syste…
-
Этот репозиторий является форком https://sourceforge.net/p/stm32flash/code/ci/v0.5/tree версии примерно v0.5?
Утилита stm32flash рассчитана на программирование через UART.
Более новые отладочные п…
-
Is there any kind of expected support timeline for STM32U073 in either stlink or openocd. I use Ada and need to connect gdb via something. Thank You.
- [ ] Programmer/board type: STLINK V3 MINIE
-…
-
I am having an issue trying to flash the NRF52832Y board and was wondering if anyone has configurations for successfully doing so.
I tried flashing it using an ST-Link V2 with the default Openocd…
-
is necesary change this lines ?
`# Uploader tool
# -------------------
# blackmagic probe upload
tools.bmp_upload.cmd=arm-none-eabi-gdb
#tools.bmp_upload.path={runtime.tools.arm-none-eabi-gc…
-
Thanks @hoverboardhavoc for his pull request https://github.com/RoboDurden/Hoverboard-Firmware-Hack-Gen2.x-GD32/pull/3
Maybe adding stm32F103 support now has become closer.
adding this to platfo…
-
nrf-recover doesn't work with STLinks. However pyocd can do it just fine, so it should be possible. I'm using a stlink v2 clone.
Error It isn't possible to recover with a ST-Link
-
Hello.
I have a problem with BDsensor after flashing STLink. I receive error 10.24. I updated the firmware according to your instructions. Before the upgrade, BDsensor worked ok. Still 'No data from …
rety4 updated
3 months ago