-
Hello,
I don't know if this is the right place to report this, but the SWDCLK and SWDIO pins are swapped in the documentation.
I had trouble debugging the PicoW(H), and it worked after swapping SWDC…
-
* please maybe TC2030? https://github.com/rusefi/rusefi/wiki/Tag-Connect-TC2030
* please maybe 10 pin TAG connector like Proteus? https://github.com/mck1117/proteus
-
Hello,
im using a BMP 2.1 updated to latest release, 1.10.2 native.
I can scan stm32 without issue, but not the S32K144. I tested with a segger j-link (as SWD) and works but only if i set swd speed …
-
```
$ openocd -f ./ocd-stm32.cfg -f target/stm32g0x.cfg
Open On-Chip Debugger 0.12.0
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
Info : aut…
-
Hi guys,
From the rp2040 datasheet(page 300), there are 2 registers named SWCLK and SWD at the offset of PADS_BANK0_BASE+0x7C and PADS_BANK0_BASE+0x80, right after the register for GPIO29. But there …
-
## Environment
- Module or chip used: ESP32-S2-WROVER
- IDF version v4.3.1
- Build System: idf.py
- Compiler version xtensa-esp32-elf-gcc (crosstool-NG esp-2021r1) 8.4.0
- Operating System: Wi…
-
Hi, I am once again struggling to make friends with kuenm_cal_swd. This time I could not retrieve any omission rate statistics with it.
My SWD files look like this:
Occurrence dataset (all of th…
-
Complex execution of binaries like in SYE: `sh.elf` with a non supported build command like cmake `cmake . -Bbuild && cmake --build build/` can benefit from this.
Checking output of an external com…
-
I am having an issue trying to flash the NRF52832Y board and was wondering if anyone has configurations for successfully doing so.
I tried flashing it using an ST-Link V2 with the default Openocd…
-
```
~/st-link-v2-clone/config$ openocd -f interface/stlink.cfg -f myconfig.cfg
Open On-Chip Debugger 0.11.0
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.h…