-
Hello,
I am trying to run the **2_porting_nrf52840 application** and when the code calls
the _sx126x_add_registers_to_retention_list()_ and sends the sx126x_read_register command via SPI with **SX…
-
**Describe the bug**
The sample lora send doesn't succeed to send the message on the nucleo_wl55jc
**To Reproduce**
Steps to reproduce the behavior:
1. Build the sample lora\send for the nucle…
-
Looking at:
https://github.com/chandrawi/LoRaRF-Python/blob/67cb5c96fd4bb95db57e176590ced4b78b3f1192/LoRaRF/SX126x.py#L103-L105
and then comparing that to:
https://github.com/chandrawi/LoRa…
-
Hi,
I'm currently working on a project that involves sending data from SX126x (connected to raspberry pi 4b) to a Mikrotik Lora Gateway and then to ChirpStack. Browsing through multiple docs and pr…
-
**Describe the bug**
When the bandwidth is set to 125kHz on the SX1262, and the SF is 8 (and only 8), sometimes packet data is incorrect when received. But CRC has been passed of course.
Debug mod…
-
PR #251 currently adds support only for sx127x, though similar functionality for sx126x requires only calling the `GetRssiInst = 0x15` Op and returning the result.
plaes updated
3 months ago
-
In the class SX126X, 'setTCXO' is called after 'config' for both 'begin' and 'beginFSK'. 'config' runs the calibration command. The TCXO needs to be configured before calibration is run. so currently …
-
Hi,
Compiled your code just fine using Arduino IDE set for Arduino R4 Wifi board.
However, when I tried setting board to ESP32 Dev Module (or other basic ESP32 boards), compilation failed. Is th…
-
### Description of defect
We are using a STM32L151CC on a custom PCB, with a SX1262 radio, its roughly based on a Nucleo-L152RE board + SX1262MB2xAS design.
Everything works reliably until w…
-
Hi!
I try to get the library running on an RPi 3b+ with the 64bit OS headless. The board I am using is the waveshare board with SX1262 via SPI and GPS via serial.
When I compare the version if …