-
Not familiar with the ESP devices, so please bear with me. Trying to program the files from the release-folder in my WeMos D1 4MB Board using ESP Tool online, but not succeeding.
Is the release suita…
-
Hi Joba,
nach langen Tüftelön mit VS Code und Platform IO habe ich Dein Skript sauber kompilieren können. Nun scheitert es bei mir an der Stelle des Uploads. Ich habe Dir dazu einmal ein Foto angef…
-
@wemos
Hey guys from Wemos,
You wrote on the main page about the Forum. http://forum.wemos.cc/
- That forum is not working now for more then 6 month.
- What's going on with you guys?
-
In new firmware with a web configurator, AP doesn't start after save config and rebooting.
Tracker works fine if all parameters were set correctly, but no more AP
Tested on T-Beam v1.2 and ESP32 Wem…
M0IGA updated
23 hours ago
-
Brother i have wemos r32 which firmware isn't publicly available, if i use this tool will it modify firmware? Please tell. (It would be a great difficulty for me)
-
hello,
i have a prb with wemos D1.
the usb to Uart i thinck
if mod your code and force serial.swap() in src/mavesp8266_vehicle.cpp
and connect my TX and RX to D7 and D8 all OK ;)
https://hobbyt…
-
Can someone help with communication and adjusting the program to the Wemos D1 Mini? Below is my configuration, in the logs I have "inventer not found" error.
serial = &hardwareSerial;
// OK pe…
-
Hi,
I have 3 Mitsubishi units SEZ-M35DA and for each I have already connected a MAC-567IF-E unit on the CN105 port. I have managed to find a CN105 splitter, see picture below so that I can also att…
-
Всем привет! Столкнулся с проблемой уже в 3х проекта (wemos d1 mini), использующих библиотеку GyverNTP (схема как в примере к библиотеке: инициируем, в лупе тикаем и при изменении секунд вывожу на лед…
-
Hi, is it possible to use this with your wemos shield board?