-
When trying to activate the flooding sensor, I encountered a strange behavior that prevents its correct operation.
Despite setting the input as no pull-up (in the active mode everything is ok - the …
-
I have two different CB2S, the one on the left in the picture has a BK7231M, the right one has a metal cover so I don't know what's inside.
The right one works fine, I can write the firmware with ltc…
gdtv updated
4 months ago
-
### The problem
Basically its messed up
CCT bulb controls are buggy at best.
- brightness control is only possible when color temperature is set to cool (white)
- brightness control is not …
-
**Describe the bug**
First Happy New Year! I got a feature request. I have a super generic aliexpress temperature and humidity sensor (doens't even have a name). Flashing and GPIOs are working, but t…
-
I'm working with ESPHome on an RGB bulb - and if I interact with the bulb for a bit, scrubbing through colours etc, the connection will eventually drop and not come back up without a power cycle.
S…
lmcd updated
9 months ago
-
Hello,
I'm fairly sure I'm doing this correctly but I am unable to open the serial connection to flash a CB3S with OBK.
I am using this USB to TTL module
https://www.aliexpress.us/item/3256805987…
-
**Describe the bug**
MQTT queue payload seems corrupted (see the screenshot attached below).
**Firmware:**
- Version 1.15.323
- Device? DayBetter 800 Lumen 120V 9W RGB+2700-6500K Bulbs
- Chip/m…
-
**Describe the bug**
Cannot Send IR command, I got a cmnd not valid message but I don't know what could be the correct command.
**Firmware:**
- Version [1.17.308]
- Device IR sender
- Chip/mod…
-
**Describe the bug**
Non programmer here. Using LSC Smart Ceiling light (RGBCW, T7231N), unable to disable "exponential brightness" feature.
Controls in web interface and HA are not accurate.
T…
-
I have purchase a smart switch from Aliexpress, but unlike what I expected the chip is not a BK7231N/T or similar but a TR6260.
By researching the web I found the following information:
https://ww…