-
I'm bringing to your attention the fact that there are a few pins between the USB connector and the SD card slot that can be used to wire up BLTouch. I measured the continuity between the 22 / PB3 pin…
-
### Description
I'm using the latest [E3V2-UBL-BLTouch-10x10-v4.2.2-v2.0.1.bin](https://github.com/Jyers/Marlin/releases/download/v2.0.1/E3V2-UBL-BLTouch-10x10-v4.2.2-v2.0.1.bin)
During the Homi…
-
Original Printer: Aquila S2
Chip: HC32FA60
Firmware: Alex's - BLTouch-4x4-HS-H32.bin
Probe: Antclab's BLtouch SMART V3.1
Hot end (not sure it matters): Haldis 3D Red Lizard Q1 V6
After installing…
-
Hello !
I am having an issue with trying to control my Ender 3 S1 Pro via Python in a Raspberry Pi (connected via micro-usb). My code is the following:
`import serial`
`ser = serial.Serial('/dev…
-
After flashing bigtreetech’s pre compiled firmware firmware-bltouch-for-z-homing.bin BLTouch no longer works correctly when you turn on machines BLTouch dose it’s test sequence and errors, all wires …
-
Sorry to open a ticket for this I was nto sure where to ask this. What exactly is the BLTOUCH supposed to do? I have everything installed and configured. It probes and all that. It does not seem to …
-
Hi bigthreetech
Ist it possible to provide the bl-touch firmwares with #define PROBE_OFFSET_WIZARD enabeld?
CAn be found in Configuration_adv.h
ty in advance.
-
I have an Ender 3 Pro with the SKR v2.0 board. I just installed a genuine BLTouch and since I didn't connect the wiring to the Z-Port, I'm using the Firmware-BLTouch.bin file. Everything powers up jus…
-
Hello,
I just added Bltouch to Ender 3. I'm using firmware provided by you (firmware-bltouch-for-z-homing.bin) I am using servo and Z Stop pins to connect my Bltouch.
After the firmware is flashed…
-
### Is your feature request related to a problem? Please describe.
Bed leveling is faster with `Z_CLEARANCE_MULTI_PROBE = 2`, but if the printer thinks the bed is a bit too low when it probes, the pi…