-
When my charging session is complete, Home Assistant shows the charger is still delivering around 325W for hours afterward. The EnelXWay app does not show this current in the charging curve. My home p…
-
We need to define the additional attributes for implementing charging activities described in #9663. Please check and, if necessary, modify them.
**stationFinder/vehicle: input parameters:**
| …
-
Better manage the overnight charging along with Octopus tariff. In my case, Octopus Agile.
In the winter, it was 99% fully charged overnight so very little logic is required to managed the grid cha…
-
Is it possible to extend pylog
to read the recommended charging currect for the whole battery pack assembly
(e.g. having multiple parallel US3000-B/C batteries, charged at once as a whole pack),
…
-
I'm using MKR 1500 NB to test. Well I'm not able to charge my 1400mAh cell with more than 100mA even I do set 500mA.
What can I do to get higher charge power?
Having a look into the Lib and doing …
Adk90 updated
7 months ago
-
While charging, the OpenUPS driver reports wrong ouput current as I know my load on output is near 20W (1,7A @12V):
battery.capacity: 100
battery.charge: 72
battery.charge.low: 5
battery.charge.wa…
-
It would be nice if one could set a treshhold where the charging will be halted when power/current gets below defined value. The idea is to set that value where the SoC is about 80%. Not all cars supp…
-
Would it be possible to add a Support for lead acid batteries on Deye Inverters?
The two main parameters battery voltage and current could be read from the inverter Modbus registers 587 and 591. This…
-
Hi @nessnaj,
This is a great repo!
I am using it to connect to my charger. I can perfectly read, but unfortunately not **write** any values to registers. pause_charging(), set_current(), ...
A…
-
### Describe the problem
The [Auth module](https://github.com/EVerest/everest-core/tree/main/modules/Auth) is a central module in EVerest that is able to handle incoming authorization requests from…