-
As per the Klipper changelog (https://github.com/Klipper3d/klipper/blob/master/docs/Config_Changes.md), several options/features have been removed.
"20211102: Several deprecated features have been …
-
z_min_probe is stuck triggered with interripts, i think it's better to disable them at least for creality boards (including dropins)
-
i am now on my second f4 mainboard that is stuck with the last firmware flashed to it. i have updated it, with correct firmware along the way, now i cant change anything it wont flash anymore
-
HI, bootloader has been erased. i cant flash with sd card, and cant connect over USB.
Can you share bootloader.bin with guide for flashing to recover my board?
-
I have two boards that were working but now show blue blank screen on stock Ender 3 LCD screen.
Board one:
Went blank after flashing new firmware. (using firmware.bin from Github), this board seems …
-
I had purchased a new SKR Mini E3 v1.2 but my TFT35 v3.0 was saying 'No Printer Attached'. I thought it was defective so I purchased the SKR Mini E3 v2.0 and had the same issue. I tried to use my TFT3…
-
Recently i bought the BTT SKR E3 mini V3 and a BTT mini 12864 V2.0 display
[https://github.com/bigtreetech/MINI-12864/tree/master/mini12864_v2.0](BTT mini 12864 V2.0). Not the best decision, but don…
-
**Feature Request:** Temperature Sensor Calibration Tool and Troubleshooting Documentation
Marlin needs a feature where you can take a known calibrated temperature sensor/thermocouple and use it to…
-
**Describe the bug**
I have a problem with my BL-Touch V3.1 on my Ender 3V2 controlled by an SKR Mini E3 V3.0 running [Ender3V2-SKRME3V3-BLTUBL-20221002.bin](https://github.com/mriscoc/Ender3V2S1/rel…
-
I spent the whole day trying to run 3D Touch with MKS Robin E3 using the tutorial https://www.youtube.com/watch?v=r2A0b7XQEaI without any success. Finally connected it on Z End Stop and it's OK now. T…