-
I run version 2021.11.5 of Home Assistant and with the VMBELO there is a gap in the sensor list. Where Velbuslink indicates heater, pump and Alarm1 pressed, HA indicates boost and cooler active. The s…
-
When I click a switch in home bridge ui, its state changes in domoticz, but lights don't actually switch. And if i click same switch in domoticz, it works fine. No errors in logs and mqtt seems to be …
-
### PROBLEM DESCRIPTION
Not possible to run firmware with MAX_DOMOTICZ_IDX = (7 or higher) on ESP32 to control more than 6 relays via MQTT
### REQUESTED INFORMATION
After getting enthusiastic ab…
-
Hi, I saw that about a year ago a similar issue was closed as it solved itself but I'm afraid my issue is not solving itself.
I istalled the plugin v1.2.0 as per instructions on my Domoticz v2022.1…
-
Hi.
I have used the stas-demydiuk/domoticz-h801-tasmota-plugin for many years in Domotics now, but have in long time, been on hold on Domoticz build 14353.
But I can't upgrade Domoticz higher th…
-
### The problem
I've two Hue Bridges in my home network, one in the house (10.0.1.150), one in garage (10.0.1.151). Both connected to the same mesh network.
They've always worked fine.
Since a coup…
-
Hello,
I've seen in Deconz you can set a percentage of how low you want to have the blinds. For example if you set 50% it will lower it to half the way.
I've seen in Domoticz the status is reporte…
-
## What happened
I Orderd a Centralite 3400 Keypad, after some investigation I saw that the supported device is named 3400-D. I don't know that is a compleet differten model?
I could pair the de…
-
When replacing a device, the Unit is not replaced.
[Link issue 5102](https://github.com/domoticz/domoticz/issues/5102#issuecomment-1017520165):
> In the next beta the logic is as following
> - Th…
-
Hi Team,
The values, that are presented by Tasmota devices through MQTT don't show any decimals.
In the Tasmota Device Manager I see that the MQTT transmitted values have decimals, so they are rou…