-
Hi,
ich hätte eine allgemeine Frage. Ich würde gerne die offizielle Firmware von Anycubic nutzen, um mein 8 Bit Board vom Anycubic I3 Mega etwas umzuprogrammieren. Leider gibt es dort nur die HEX-Da…
-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …
-
Has anybody used this hardware and schematic with esphome as the software? I've got all the hardware and printing a mount but I would like to integrate using esphome and home assistant preferably.
-
I hope this is the right way to suggest Wiki (documentation) updates.
Here are few suggestions based on my working with the software:
1) I did not know understand about the Flash settings. I did…
-
i got a SKR3 with a diff MCU (STM32H723VGT6). look like Marlin Firmware can load, as firmware.bin has change to firmware.CUR. But USB communication with PC are not alive, no COM Port detected. Any one…
-
Разработка основной "стандартной" конструкции робота для бассейна
-
Good day. after the firmware I wanted to activate wi-fi. Throws this error. Which is from BTT, which is from teamgloomy.
Can anyone understand what the problem is?
18:45:20.169 : No start signal d…
-
When activating dual x carriage, sanitycheck wont let it compile:
# error DEPENDENCY ERROR: Missing or invalid definitions for DUAL_X_CARRIAGE mode.
Pins are sorted out, steppers are defined, but it …
-
You use 12v stepper motors. Try motors which are spec'd at 3 to 4v.
Those 12v stepper motors are inappropriate for 3d printers/plotters etc.
I have a bunch of 12v steppers and they collect dust in …
-
bresenhamstep is called from the isr to do very important work, and it has to do it fast.
I wonder if there is more we can do to speed it up.
I figured we should have a single place to discuss this as…