-
Hi,
I think it would be nice to see a notification when filament runout is detected.
-
Hey just a small update for the Klipper N3P config. The filament sensor type appears to be a switch instead of a motion sensor. It kinda works as-is but it usually pauses the print right at the begi…
-
Hi @furbrain!
At our local caving club we have received the SAP6 and have already field-tested it. There were some changes in measurements compared to the Disto-X2, but the Disto-X2 was not calibra…
-
n this dual XY core and common Z configuration, you'll need to control the independent XY movement of both print heads, which requires additional stepper motor drivers and pins. Additionally, you'll s…
-
It seems like I now and then get an error like this:
"An issue with the MMU has been detected whilst out of a print
Reason: Load sequence failed: Failed to reach toolhead sensor after moving 40.0m…
-
Hi
How can i query the status of the plugin. I fear it does not work.
I secured my haproxy with authentication. How can i supply this with netcat ? Is this even an issue ?
I tried to go to the hapro…
-
**Describe the bug**
A clear and concise description of what the bug is.
Spools have a couple hundred grams of filament left when Filament Manager reports it is empty. This has been consistent on …
-
Excellent stuff, no more running to the room where the printer is...
My standard GCODE has a Tx followed by commands to heat up (and wait for heating up) and a Tc to load.
The choice on octoprin…
-
Hey - just wondering if it might be possible to implement a mid-print filament change for when an `M600` command is sent to printer.
I've been doing a few prints lately which have different coloure…
-
This plugin doesn't work for me. Tried two scale setups with the green board. Under current reading NaN is reported and nothing can be calibrated.