-
Hi,
I want to setup an accessory to act as my sliding gate remote. I have already done the logic after MQTT message is published.
I want the interface of the accessory to have 3 buttons, which trigg…
-
Hi guys,
i don't know if it is bug or something wrong in my configuration. My Sonoff SV is flashed with Tasmota firmware 8.5.1. and i use it as garage door opener without any sensors. Because the gat…
-
As I understand, the garage door opener motor should rotate several times until the door is fully open.
def trigger() :
for i in pinList:
GPIO.output(i, GPIO.LOW)
tim…
-
From a fully factory reset Liftmaster garage door opener…I added five remotes to it in total.
In the myQ app, under myQ Diagnostics, it shows (correctly) 5 remotes (and 0 keypads).
In the Ratgdo…
-
Axios Socket fails when switching MSS110 device.
--
### Details of your setup.
* Do you use (1) Homebridge UI-X (2) Homebridge CLI or (3) HOOBS?
1 Homebridge UI-X
* Which version of Homeb…
-
Hi,
I have garage door openers and smart hub and I got the following errors constantly in the log
`2024-10-16 09:58:02.310 ERROR (MainThread) [meross_iot.controller.device] GenericSubDevice does…
-
Hi!, the "garage-door-opener" is recognized like "thermostate"; reverting to 3.6.15, and all back to work flawlessly.
Thank you for your hard, hard work.
-
I have everything mostly working but have a few small issues / questions.
Sometimes after pressing the garage door opener in back to back operations (1st operation completes before I press again) s…
-
Looks like HA is printing these warnings for the alarm panel pro and the garage opener (same message).
```
2023-11-19 10:31:28.264 WARNING (MainThread) [homeassistant.components.sensor] Entity sen…
-
I have 2 garage doors and the opener controls are directly next to each other. I would like to control both from the same pi, this would require a little more configurability and the ability to both h…