-
The myicomfort custom integration is using deprecated climate auxiliary heater
This stops working in version 2024.10.0. Please address before upgrading.
The custom integration myicomfort implements …
-
Tested this firmware on ZANUSSI ZWH/S ARTENDO PRO-C Wi-Fi. Everything works great!
For my wi-fi dongle (not Dudanov's iot-uni-dongle) swaping RX and TX pins in configuration was needed.
If your don…
-
It would be great to have 1-2 channels of heater control. This probably wants some sort of digipot/pwm + MOSFET combination. It needn't be fast, so sticking it on the i2c bus seems very sensible. T…
rwb27 updated
6 years ago
-
From Home Assistant Community Post: https://community.home-assistant.io/t/panasonic-aquarea-heat-pump-integration/392095/31
The water heater entity supports the following operations, but it doesn't…
-
Is it possible to get wemo holmes heater support?
-
### The problem
Hello, I just added my somfy Screen, Pergola and Heater to Home Assistant via Overkiz.
Pergola and Screen working perfectly. Only the heater is not really working. No switch entity a…
-
**Hardware (please complete the following information):**
- 2021 (Miami)
- 6 wires
- Custom
- None
**Software (please complete the following information):**
- Version 2024-07-07-2211
H…
hosek updated
2 weeks ago
-
It's currently possible to send `NaN` in console, as per below;
```
SET_HEATER_TEMPERATURE HEATER=extruder TARGET=NaN
```
In this case, Klipper starts heating - and will error once it exceeds …
-
Hi, I have been using the k3ps marlin firmware for a while, recently the MOSFET of the Heater 0 burnout, I want to know if there is a way to use heater 1 by default, I know it can be done by switching…
-
This seems to not work with fermenter. Only with Kettle?
Would it be possible to use with fermenter?