-
Hi, thanks for your efforts, this is a fantastic project!
but I having issue to connect the printer via USB serial port, running `tail /tmp/klippy.log` in ssh it shown:
```
localhost:~# tail /tmp…
-
It's currently possible to send `NaN` in console, as per below;
```
SET_HEATER_TEMPERATURE HEATER=extruder TARGET=NaN
```
In this case, Klipper starts heating - and will error once it exceeds …
-
I'm running Klipper on an Ender 5 Plus and under the Move controls the up / down arrows for Z axis are inverted. On fluidd there's an option to Invert Z control on Settings > Tool. I was wondering if …
-
When attempting to restart the service, I get the following errors. When I run the `klipper_ledstrip.py` command, the LED strip response as expected.
`pi@sv01-mainsailos:~/Klipper-WS281x_LED_Status…
-
The main PT100 board has jumper settings specified for 3 and 4 wire configuration (shown under the board) this instruction is showing two wire thermometer.
Can you please show a diagram how a 3 and…
-
I get the following in /tmp/dwc2.log
`
========== Started ==========
ERROR:tornado.application:Exception in callback functools.partial(, )
Traceback (most recent call last):
File "/home/pi/dwc-…
-
The SKIPR board uses for klipper configuration normaly Bootloader offset (48KiB bootloader (MKS Robin Nano V3)). So in my mind I should in CanBoot configure the Application start offset to 48KiB - or …
-
Hello,
compliation ends with:
```
Version: V1.1.0.12-0-ga63fb1a-dirty-20240110_095629-klipper
make: *** No rule to make target 'out/src/prtouch_v2.o', needed by 'out/klipper. …
-
Good afternoon, faced with problem drivers tmc2208 bt fysetc
https://aliexpress.ru/item/32848553467.html?spm=a2g39.orderlist.0.0.4b8b4aa68oAwrM&_ga=2.102432385.1279670221.1630433926-2024624615.1628…
-
hey i saw your klipper firmware and config, and i decided to give it a go, how would i level with pr touch?