-
In the file MPU6050.h, line 417, the wakeup cycle frequency is defined as such:
# define MPU6050_WAKE_FREQ_1P25 0x0
# define MPU6050_WAKE_FREQ_2P5 0x1
# define MPU6050_WAKE_FREQ_5 0…
-
Hi everyone.
I am using an Arduino Mega, and the MPU6050. I tested the MPU6050_DMP6 example and the Arduino crashing after a while. after extensive testing, I am reading raw data directly with getMoti…
-
Hello!
I am using Arduino Uno to connect two mpu6050.
I know they use different I2C addresses, and they seem not to work simultaneously.
When one mpu6050 works, the other mpu6050 doesn't.
…
-
which direction should i mount the GPS . What is the relation to the axis of mpu6050?
-
I get an error
```
mpu_test:9:26: error: no matching function for call to 'TwoWire::TwoWire(int, int)'
9 | TwoWire CustomI2C0(10, 11); //important
| ^
In file i…
-
Hello,
I have got a small PCB board which has GPS(BN220) connected and it works fine
```
Second analog to digital sensor is not detected
Foreseen GPS type is Ublox (configured by oXs) :GPS i…
-
The code won't compile, I was copying files from the browser, but later I downloaded the .zip and did all again. I still get these messages:
In file included from Measure_angle_Arduino_MPU6050.…
-
### The problem
When you enable the camera on the I2C bus the scan will detect all the I2C devices yet only the Camera seems to optimizes the bus and no other devices respond.
ssieb pointed to t…
-
Hi,
when running the dmp examples, calibration never finishes (infinite "*" are printed).
Commenting out the `mpu.CalibrateAccel(6);` makes it run fine. However then it is not calibrated i guess?
…
-
Hi there,
I'm currently working on a project related to MPU-6050, arduino, and labview software for simulation. I have poor knowledge in C or C++ PROGRAMMING. I need to use 2 mpu-6050 sensors to captu…