-
Hi,
Can you add support with this otgw software:
https://github.com/rvdbreemen/OTGW-firmware
thanks
Anton
-
In the home assistant opentherm gateway integration I ran into a setup problem, where the setup never succeeded. The source of the problem seems the be an SE response on the first PS request.
init_…
-
Hi is it possible to have the entity icon coloured even when off or permanently coloured like for a scene? At present the icon is olny coloured when on? Thank you for your lovely work!
entity…
-
### The problem
When booting Home Assistant the OpenTherm Gateway fails to load.
When I manually click reload it fails again. This keeps happening over and over in an endless loop.
Somehow, sometim…
-
Hello,
Do you think is possible to send Room Temperature and Outside Temperature from HA to opentherm ? I'm running nodoshop's opentherm gateway in conjuction with your OTGateway and it supports ID24…
-
### The problem
Hi,
I'm trying to add my OpenTherm Gateway to Home Assistant. I have a working gateway that is working via otmonitor either via the USB-serial connection or directly from TCP using…
-
Probably better to share these graphs here and not on HA forum.
As promised some further graphs. I set aggression to 3, overshoot to 30. To note, until 7am the heat pump was in night mode, capping …
-
Logger: homeassistant.components.mqtt.models
Source: components/sensor/__init__.py:593
Integration: MQTT (documentation, issues)
First occurred: 15 september 2023 om 21:30:28 (82778 occurrences)
L…
-
I’am at a loss.. I can’t figure out what the best way is to approach my situation. Perhaps you have some insight.
currently:
Tado controled system with radiator plugs.
Floor heating downstairs. A…
-
Situation house 1900, insulation moderate/reasonable, floorheating and rooted tone1 as a thermostat in the livingroom, then a connected OTGW, there is a zone valve in the supply of the underfloor heat…