-
When I try to pick pisugar version in the window pop up during installation it doesn't allow me to navigate or select anything. I looked for similar posts and I'm sure this could potentially just be c…
-
Hello, more of questions than an issue. First of all, love the product. When I bought the PiSugar 2 Pro, it mentions that because the connector is a standard PH2.0, battery swaps are possible. This pr…
-
I am working with two Qwiic sensors connected to a raspberry pi zero via a qwiic pHAT. When the pHAT is not connected the I2C addresses of the PiSugar2 can be detected and data can be read from it. Ho…
-
I know this sounds kind of basic, but I can't seem to start the battery pack.
I've done the quickstart steps: Screwed the pack to the Pi 3, connected power to the pack, pressed the reset button f…
-
I have currently been trying to connect my Raspberry Pi Zero 2 W with the PiSugar 3 Plus. Everything is wired, and the pi is getting power, however, it is failing to find any of the i2c connections wh…
-
Will this board/battery be sell someday ?
-
Does it support Pisugar 3 Plus? I'd like to get it for my Raspberry Pi 3A, and I'm not sure if this plugin will work with it.
-
Hi!
I have a PiSugar 2 Pro, and I'm a bit confused about the correct procedure for shutting down and starting up again.
The first time I used it, I pressed the "Activate" button for 2 seconds, t…
-
#### Description
All i2c addresses are set following the manual firmware update for Pisugar 3 Plus in an attempt to get the RTC to function.
Prior to update only addresses 0x57 and 0x68 were set.
…
tetac updated
2 months ago
-
I've set the single tap button to Custom Shell.
I entered the following: ~/bender/start_usb.sh
I also tried: sh ~/bender/start_usb.sh
I also tried making the script executable.
The script…