-
### Steps to Reproduce
Hey folks,
I just switched from pi 3b to a Pi zero 2w. I don't have any external power so i was using power from the battery and seems like it wasn't enough and kept gettin…
-
-
The power consumption after I deepsleep it with microPython is 1 ma, should it be lower?be like10 uA
-
We should expose the heating/wire mode for the NodOn SIN-4-FP-21 and Legrand cable outlet to Home Assistant.
Related PRs:
- #3364
- #3031
Concerns were raised that we would not conform to Home A…
-
The calculated power consumption of 12V WS2815 is off by 100%. 300 physical LEDs result in 48W, when it should be 90W. Any WS2815 strip i checked online stated 0,3W/Led or 90W/strip for 60Leds/m.
Pl…
xrtze updated
5 months ago
-
How can I see the power consumption?
The air conditioner is connected to the companion. The original app shows the power consumption.
-
Hi all!
I am building a simple water sensor that reads a water level from a touch PIN, packs the result into a BLEAdvertisement and goes into deep sleep.
However, during deep sleep the consumption…
-
### What happened?
This morning (more than 10h ago), I switched off the printer using the plug switch, as you can see here:
:
* Active: 50-60 mA
* Sleep: 0.5 mA @ 4.1 V = 2.05 mW
The load cell + amplifier (measured on 3.3 V line):
* Active: 10 mA
* Sleep: 0.0…
-
Find out how much power a Raspberry Pi 5 consumes when idle and when under load. This will help us understand better how much total power we will need.