-
**Describe the bug**
Running `hf 14a apdufind` crashes the `proxmark3` client.
**To Reproduce**
Steps to reproduce the behavior:
1. Put 14a tag on proxmark
2. Run `hf 14a apdufind`
3. `proxmar…
-
**Describe the bug**
After a successfully dump of a 4K mifare using `hf mf autopwn -s 0 -a -k [key] --4K`, I tried to load the dump on a mifare classic 4K (Magic Capabilities: gen3/APDU) with the c…
-
**Describe the bug**
I would like to use the Smartcard reader but cannot upgrade the firmware :
```bash
[usb] pm3 --> smart upgrade -f sim011.bin
[=] ------------------------------------------…
-
in recent build ( as of todays date) i now get constant UART errors in any action - build was with out error, flash was without error. Re cloning and rebuilding / flashing results in the same error on…
-
**Describe the bug**
issue when running pm3 in terminal and then dumping.
when dumping a card in a shell opened with the pm3 command it dumps it to ~ but when it tries to read it it tries to find …
cvanh updated
2 years ago
-
**Describe the bug**
When building the client from source on Termux, `hf mf hardnested` causes a SIGSEGV, but when it is compiled with `make client DEBUG=1`, it does not cause the same issue. I think…
-
***flashing problems***
Have you followed the instructions properly? ie, flashed bootrom seperately first if you are going from Offical repo to RRG/Iceman repo.
**Describe the bug**
I recently …
-
**Describe the bug**
Since commit 763c943 (two previous ones didn't compile) the PM3 (RDV 4.01) isn't recognized anymore on USB and BT.
On linux, lsusb hangs until I unplug the device.
Checking out…
-
**Describe the bug**
There are errors flashing the PM3 Easy line of devices using ``pm3-flash-all`` on MacOSX. The generic build of the firmware is installed by running
```bash
brew reinstall --wit…
-
**Describe the bug**
I have MFD EV2 (in factory default). When I start client and run `hf mfd info` everything is OK. When I run it **second time**, section _Tag Signature_ will fail with message `…