-
I don't have the CM15PRO however I've been using Mochad for a couple years now with a CM19A.
I managed to setup pimatic-mochad to talk to Mochad but the codes sent from pimatic-mochad don't seem to tr…
-
Hi,
I want to ask you how to use this library, I know this is a very stupid question but I am doing such kind of work for the very first time. I need to your help. I have 2 Raspberry Pi 3 model B, I …
-
Just for the info - may be helpful:
I've bought https://www.ebay.com/itm/HM-10-CC2541-CC2540-4-0Bluetooth-UART-Transceiver-Transparent-Serial-Port-NEW/381374587590?ssPageName=STRK%3AMEBIDX%3AIT&_tr…
zdila updated
4 years ago
-
Hi Christian,
What a great project! Especially because i've been working on a home domotica solution for the RPi for about a year now, that since about two months is known under the name pilight (htt…
-
I've been wondering if it would be possible to interface this with another project (https://github.com/F5OEO/rpitx) to be able to use the on-board GPIO pin for local TX (given proper filtering, of cou…
-
I looked for any docs of this fork, but couldn't find any. Maybe I'm totally wrong here.
I was looking for a way to control a 868Mhz radio device. Ideally with tasmota and the CC1101 I have laying ar…
-
### The problem
Hi there, I have tried a lot of time, to fix this problem by myself
I have a Novy Hood and a Novy 840029 RF Controller.
I have flashed ESP-Home on my Sonoff RF Bridge and instal…
-
I don't have these, so I was unable to create the appropriate message classes:
- CO Detector
- Freeze Sensor
- Water Sensor
If you have them, please post the raw output below, along with what ca…
-
### Description of the setup:
* Device: Red Pitaya 125-14
* SD card image: red-pitaya-alpine-3.6-armhf-20180523
* Application: sdr-receiver-hpsdr
* Other relevant information:
### Descrip…
w2naf updated
6 years ago
-
I have started building your opentilt platform, and got some v2 pcb's fabricated, I notice your instructions only show version one.
Any chance of adding a pic of version 2 assembled, I have started…