-
wio nodeでGrove CO2 & Temperature & Humidity Sensor SCD41に対応してほしいです。
https://wiki.seeedstudio.com/Grove-CO2_&_Temperature_&_Humidity_Sensor-SCD41/
ご検討よろしくお願いします
-
From yesterday, every 10 minutes I take measurements (NodeMCU + CCS811). In the code I have ```delay (300000);```. I send measurements to my InfluxDB database. I visualize them using Grafan. Here are …
-
### PROBLEM DESCRIPTION
The console commands for the SCD40/SCD41 sensor are not recognized (scd40cal, scd40test, etc.) I compiled my own binary with support for both the SCD30 and SCD40/SCD41 sen…
-
Working on [ESPEasy](https://github.com/letscontrolit/ESPEasy/), a plugin based IoT solution for ESP8266 and ESP32, we have been struggling with keeping sketch size as small as possible.
Using this l…
-
Hi,
I bought both the sensor module by itself (Digikey# 1649-SCD41-D-R2CT-ND), as well as the dev kit for scd41 (digikey# 1649-SEK-SCD41-SENSOR-ND) from digikey. Running the basicReadings example, …
-
MicroPython code using SCD41 seems to run fine once but pressing stop crashes the RP2040 and requires a USB unplug/replug before the sensor will read again.
I can replicate this on a Plasma 2040 an…
-
I've just started using SCD41 evaluation module with an Arduino UNO for preliminary test purpose. It works with your provided example, but I found that the measures takes about 1 minute to stabilize, …
-
I am trying to set the ambient pressure via the `set_ambient_pressure` method. From the datasheet I took that the value needs to be in hectopascal if I am not mistaken. So I am trying the following:
…
-
The SCD41 sensor is delivering values of 0 ppm for CO2; whilst Temperature and Humidity readings appear normal for this device (albeit different than readings from Urban board sensors).
This is lik…
-
Hi,
We are calibrating some SCD41’s together in a fixed CO2 environment (500ppm). After calibration we noticed big differences between the sensors.
In the datasheet:
“ 3.7.1 perform_forced_re…