-
When running this with a SHT30-D sensor connected via i2c to a raspberry pi, I can't use the method measure_single_shot() without getting an exception.
start_periodic_measurement() and blocking_read_…
-
This code works very well (indeed, thanks) on Heltec but I can't make it work on a generic DevKitC-v1 ESP32 with external RFM95. My approach has been to adjust a Lolin-d32 file and get the pin mappin…
-
### Board
ESP32 S3R8
### Device Description
LilyGO T-Display S3
### Hardware Configuration
GPIO43 is suggested by LilyGO as the I2C pins, they are brought out to the JST connector.
I …
-
### Checklist
SHT30 has been an option in the dev build for at least a year now, when will it be moved to normal build? Thus not requiring used of the dev build?
- [ ] This issue describes what is …
-
Hi, I've got an AirGradient DIY Air Quality Sensor (Pro Version PCB Version 3.1).
With the original firmware, temp, humidity, co2, and pm2.5 values were displayed on the oled panel and were uploaded …
-
After a while (tens of minutes, maybe hours) the lines
h = sht30.readHumidity();
t = sht30.readTemperature();
begin to return just NaN.
Restarting the board fixes this for another few tens of minu…
-
Homie is a wifi framework for the ESP8266, and relies on ArduinoJSON. 5.11.0 causes it to break in ways that I don't fully understand. I've included some output at the bottom. It compiles correctly wi…
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
I am running the following with a DHT11 attached, but would really want this to work with the SHT30.
- [ ] The title of this issue is "to the point" and descriptive.
Build:⋄
20103 - Mega
Librar…
-
P.7 ステップ1のNoteにある、 CLIとは みたいに、外部リンクだけの箇条書きは最初の1行目のところの出現箇所でリンクする