-
I want to change the camera I use for Indi-allsky. Previously I was running an Altair Gpcam 130M. I've done an update and run sh.setup as per the instructions. I still can't see the new 678 on indi-al…
-
Промежуточной прошивается нормально, вытаскиваю батарею, обновляю страницу. Подключаюсь повторно для прошивки zigbee после нажатия на Start Flashing, начинается прошивка, статус 0% и почти сразу диско…
-
I hope this is a simple issue:
I have used ZWO cameras with the 585 sensor on my indi-allsky just fine, but when I attached my svbony sv705c I could never get a camera to detect.
It is there in …
-
I see now an option "Sensor in "LowPower mode" in the config. I have a LYWSD03MMC.
What is this doing when on or off?
-
Thermometers with hardware version B1.4 have reading fluctuations. This is not the case in B1.7. Is this typical for this version? Can something be done about it?
Normal:
![Screenshot_20231029-…
-
Hello.
I want to make an offset, e.g. **-0.04** degrees.
When I put this number in a field in TelinkMiFlasher.html and press save, then load config - the offset is "0".
Can't understand - is it rou…
-
Hello,
I'm hoping someone can help please.
Firstly well done to AM for a great (and free) piece of software. Had no real issues once I increased the memory swap size to 5gb. But I've been trying to …
-
Problem with Image saving after update to last version.
Hey! I updated indi-allsky to newest version and now I have problems with image saving. Previously, I migrated DB to MariaDB, everything work…
-
I had gpio working with "AllSky"; decided to check out "Indi-Allsky" and am getting the following error (I have a dew heater and fan devices installed and setup; I re-ran setup script to make sure gpi…
-
I was building this for my SteamDeck and noticed that during compiling, it was building things like drivers for Wifi Chipsets the Steamdeck doesn't have, as well as things like Nouveau.
Would it ma…