-
bootloader upload firmware after each reset (power on) if firmware.bin present on card
**steps to reproduce**
1. Compile marlin with USB mass storage enabled
2. Write firmware.bin to stock 128Mb …
-
Firmware 2.0.7.2
FAN0 always on from power up (part cooling fan)
Only started doing this today, for the past few weeks it’s been fine.
Now it doesn’t respond to gcode or the settings via the…
-
I've been trying to get a BLTouch setup with my Ender 3 and E3 Mini 1.2 board. But the firmware won't load and i get a TMC Connection Error.
What does this actual error mean?
I've tried compilin…
-
### Description
This is BOTH a bug report and a feature request.
The SKR Mini E3 V2 is a drop-in replacement for the Creality Ender 5 Plus Printer.
The SKR Mini E3 V2 and the SKRV14Turbo BOTH…
-
hey folks, i could greatly use some help. first off let me tell you my skill level. I'm one of those that can learn things if given the right tools and pointed in a good direction. can figure stuff ou…
-
half of the songs don´t stop at the end
had to add this for the macro to work
[output_pin beeper]
pin: PC0
pwm: true
-
Hello, I am having the no printer attched issue with my printer. I have an Ender 5 plus with an SKR 3 EZ and a TFT50 V3.0.1. I will provide my configuration.h below but I have followed the manual, and…
-
I just received and installed my BigTreeTech TMC 2209 Drivers for X/Y/Z/E in UART mode and defined the 2209 drivers in this branch of Marlin. During homing, the X and Y axes do not register the endsto…
-
Can you provide the configuration files used to built a precompiled firmware?
-
I purchased the new SKR 2 board to replace my SKR 1.4 Turbo on my printer. After installing the board I used the version of Marlin that I downloaded from the BTT GitHub SKR 2 files. I compiled the fir…